Moat Deck Iron

Yesterday, my special-order 7″ moat deck iron came in the mail! Amazingly fast from Lunenburg foundry in Canada. I ordered it about 10 days ago. It seems than no foundry or supplier here in the US has moat deck irons larger than 5″. Andrew at Navigator Stove Works suggested I try Lunenburg since he couldn’t provide the large deck iron. We could have used a 6″ one, but took the advice of Andrew Craig-Bennett of the online Wooden Boat Forum to go with a larger deck iron so that we could further insulate the wood deck from the hot stove pipe. This requires us to take the 6″ pipe up through the iron to a point about 8″ above deck, pack with stove string and seal it with a bit of cement. Then, the exterior chimney is fit over the top of the “stub.”

The deck iron (bottom view):

deck iron

Here’s the full installation of the moat deck fitting:

We used a wood block above the deck. The moat actually doesn’t even end up being down in the deck–it is suspended above it just a bit. We did use a jig saw to do the curved cuts on the blocking and separately through the deck. The Bosch 1590EVS jig saw was used and it is a good saw for keeping the blade straight but if you don’t hold it just so…you’ll end up with a cone rather than a straight cut.

The vertical/angles are all a bit tricky. The center point of the hole thru the deck was measured from the inside and a pilot hole put through the deck from the inside; the actual hole thru the deck was traced onto the deck from the outside and cut from the top down. The hole was cut a little small as the angle of that cut is more perpendicular to the deck which, of course, has camber so isn’t quite right. David tried to make that cut vertical, but was eyeballing it as he went. We then used a rotary sanding “tube” thing on the drill to sand the sides to the correct “vertical” state which is actually an angle thru the deck.

The thick mahogany blocking on top the deck had the shape cut out with the jig saw–both inside and out. However, these cuts were made through the top of the blocking (while it was NOT on the deck) and then the correct camber was traced onto the side of the blocking and the blocking bottom was cut and sanded to the proper camber and bedded onto the deck.

We made our blocking a couple inches larger diameter than needed but we thought we might end up putting a framework over the smoke head to keep lines from fouling on it and we’d attach that metal framework to the blocking rather than the deck. Thus the whole thing ends up being very large.

Pic of David checking out the line (on the overhead below deck) before cutting the entire hole:

1deck

The deck iron sitting in the too-small hole (before the hole was sanded out) so we could check the level and figure out how we’d cut the wood blocking for the camber.

deck2

In this pic below, the wood block has been mostly cambered and now we’re looking at cutting the hole in the middle and the curve on the outide edge. Along the left side you can see 4 of the sanding things I was talking about using with the drill–there’s one on the drill–to make sure the hole thru the deck is “vertical” too.

deck3

Here, below, the curves have been cut and edges sanded to be vertical. The wood block is already bedded so there’s tape over the wet bedding material and more taping done so that the deck iron can be bedded and fastened into place.

deck4

Finally, the deck iron is bedded in place, tape removed and David cleaning up the edge of the bedding material.

deck6

Leave a Reply

Your email address will not be published. Required fields are marked *

Google Analytics Alternative